Advertisement
Quick Links
Multi Pro
Manual Workman
Model No. 131-3302
This product contains a chemical or chemicals known to the State of California to
Use of this product may cause exposure to chemicals known to the State of California
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note: Remove the cargo box or flatbed from the vehicle before installing this kit; refer to the Operator's Manual for the vehicle.
Note: For Non-TC models, install the Rear PTO Kit before installing this kit; contact your Authorized Toro Distributor
about purchasing this kit.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
WM Turf Sprayer Finishing Kit
®
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
to cause cancer, birth defects, or other reproductive harm.
Description
Drive-shaft-shield bracket
PTO drive shaft
Woodruff key
Set screw
Drive-shaft shield
Clip
Flange-head bolt (1/4 x 3/4 inch)
Hydraulic hose (5/8 x 55.6 inches)
Hydraulic hose (5/8 x 85.2 inches)
Male quick coupler
Female quick coupler
Tube clamp
Clamp bolt (5/16 x 1-1/2 inches)
Cable tie
No parts required
Register at www.Toro.com.
Utility Vehicle
WARNING
CALIFORNIA
Qty.
1
1
1
2
1
2
2
1
1
1
1
2
1
3
–
Form No. 3389-137 Rev A
Installation Instructions
Use
Install the drive-shaft shield on the
sprayer pump.
Install the PTO shaft and the drive-shaft
shield to the sprayer pump.
Install the hydraulic hoses for the boom
lift cylinders.
Couple the PTO shaft to the transaxle.
Original Instructions (EN)
All Rights Reserved *3389-137* A
Printed in the USA
Advertisement
Related Manuals for Toro 131-3302
Summary of Contents for Toro 131-3302
- Page 1 Note: Remove the cargo box or flatbed from the vehicle before installing this kit; refer to the Operator’s Manual for the vehicle. Note: For Non-TC models, install the Rear PTO Kit before installing this kit; contact your Authorized Toro Distributor about purchasing this kit.
- Page 2 Installing the Drive-Shaft-Shield Bracket on the Sprayer Pump Parts needed for this procedure: Drive-shaft-shield bracket Procedure 1. Remove the 2 bolts at the left and right of the input Figure 2 shaft of the sprayer pump (Figure 1. Drive-shaft-shield bracket 2.
- Page 3 Figure 3 1. Woodruff key 2. Slot Figure 5 1. Flange-head bolt (2) 3. Drive-shaft shield 2. Apply anti-seizing compound to the pump shaft and 2. Clip (2) the Woodruff key. 3. Remove the 2 set screws on the PTO shaft end (Figure Installing the Hydraulic Hoses for the Boom Lift Cylinders...
- Page 4 4. Remove the cap from the T-fitting in the hydraulic tube next to the transmission-oil filter (Figure Figure 6 1. Female end of hose 3. Male end of hose 2. Male quick-connect 4. Female quick-connect coupler coupler Figure 8 2. Assemble the female quick-connect coupler onto the 1.
- Page 5 Coupling the PTO Shaft to the Transaxle No Parts Required Procedure 1. At the front yolk of the PTO drive shaft, align the socket of the front yolk with the splines of the PTO output shaft on the transaxle (Figure 10).
- Page 6 Notes:...
- Page 7 Notes:...