Connecting The Breathing Circuit; Installing The O 2 Inlet Port; Starting The Device - Philips Respironics E30 User Manual

Specifications
• Uninterruptible Power Supply: 110 to 240 v
• Operation time: > 1.5 hours
3.5

Connecting the breathing circuit

Warnings
Do not pull or stretch the tubing. This could result in circuit leaks.
Inspect the tubing for damage or wear. Discard and replace the tubing as necessary.
To use the system, connect the tubing to the air outlet on the back of the therapy device. Configure the
breathing circuit based on patient needs.
3.6 Installing the O
See instructions accompanying the O
3.7

Starting the device

1. Supply power to the device. Once the device powers on, the Home screen appears.
The first time the device is powered on, a pop-up may prompt you to set the time on the device. The
default setting is Greenwich Mean Time, but you may adjust the time in 30 minute increments to match
your local time zone. If you choose to skip this initial time setting, the time can always be adjusted under
the My Setup menu.
Note
This time setting is not displayed as a clock function on the device. It is only used to align a patient's
therapy data with the provider's data reports.
2. Put the breathing circuit assembly on the patient. Refer to the instructions provided with your
accessories.
3. Press the Therapy on/off button (
current delivered pressure will display on the screen.
4. Make sure that no air is leaking from the patient interface. If necessary, adjust until the air leak stops. See
the instructions provided with your accessories for more information.
5. Press and hold the Therapy on/off button for 2 seconds to turn off therapy.
inlet port
2
inlet port for setup and other additional details.
2
) on top of the device to turn on airflow and begin therapy. The
Philips Respironics E30 User Manual
Device setup 19