Yamaha MTX Series Setup Manual page 141


Settings in the "MATRIX" screen
Here you can specify which input channel will be sent to which zone. For details on send level and other parameters,
refer to "MTX-MRX Editor User Guide."
In this example, make the settings shown in the above illustration. Clicking or dragging a cross point (a square area)
will switch it on/off. Right-clicking a cross point will display a context menu. By selecting [All OFF] you can turn all
cross points off. The cross point shows the send level as the height of green.
With these settings, Event Space Mic1/2 are sent to the Event Space area, BGM (Luxury) is sent to the Luxury area,
BGM (Casual1) is sent to the Casual 1 area, BGM (Casual2) is sent to the Casual 2 area and Casual 3 area, BGM1 is
sent to the Food Court area, and BGM2 is sent to the Entrance area and the Restrooms area.
The PGM1 which is assigned to CH1 is specified in the following "ZONE" screen. If CH1 is turned on in MATRIX,
the input from PGM1 is output to the zone even if PTT is off.
The input channel faders in the lower left of the screen indicate the input level for faders that are grayed-out, and indi-
cate the input channel send level for faders that are not grayed-out. Grayed-out faders cannot be operated in this screen.
Paging signal flow
ZONE 1-8
PAGING
PAGING
DUCKER
PAGING
SOURCE
From INPUT CHANNEL POST ON 1-16
From STEREO INPUT CHANNEL POST ON 1L-3R
From DIRECT INPUT POST ON 9-16
From ANC BUS 1-2
*1 From YDIF IN 1-16
*1 DISTRIBUTION MODE only
Example 5) A system using the PGM1 for paging
2nd PRIORITY 1st PRIORITY
GR GR
PRIORITY
PRIORITY
DUCKER DUCKER
MIX
MIX MIX
PRIORITY PRIORITY
SOURCE SOURCE
ZONE OUT
ANC
MASTER
METER
LEVEL
D ON
ANC C
8
A
AMBIENT
To YDIF
METER
OUTPUT
AMBIENT
PATCH
SOURCE
MTX Setup Manual
141