Figure 5 Inserting A Compactflash Disk Into Socket - Motorola ACC/RTB-735R2 Installation Manual

On-Board Connectors
Removal Procedure
1 - 10
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Note: In order to configure the card to the supported true-IDE mode, the
card must already be inserted when the board's power is turned on. In-
serting the CompactFlash while the board's power is still on will config-
ure the CompactFlash disk to PC Card ATA mode which is not supported
by the CPU board. If you have accidentally inserted the card while the
board's power has been turned on, you need to remove the card again
and reinsert it with the board's power turned off.
5. Plug CompactFlash disk into socket
The CompactFlash disk is connected to the socket if the ejector pin
on the front panel is pushed out of the recess.
Figure 5: Inserting a CompactFlash Disk into Socket
6. Turn on CPU board's power
1. Turn off CPU board's power
2. Press ejector pin
The ejector pin loosens the CompactFlash disk from the socket.
3. Remove CompactFlash disk from RTB
4. Turn on CPU board's power
Installation
ACC/RTB-735R2/736R2