7.3 Function Cc_Rocoreread - Siemens SINUMERIK Series Function Manual

You cannot read in the configuration file while ROCO is active. An attempt to execute this is
rejected with an alarm.
The configuration file is in subdirectory "ROCO_COMP" of the "COM.DIR" folder. The name
must comply with the following syntax:
ROCO<n>_CH<c>.DAT
Syntax
CC_ROCOREAD(<File number>)
Meaning
Parameter
<File number>:
Example
CC_ROCO(0)
CC_ROCOREAD(1)
...
7.3 Function CC_ROCOREREAD
Description
Using function CC_ROCOREREAD, you update the description data for the tool and where
relevant, the tool carrier. The update is necessary after each tool change as the masses and
moments of inertia at the flange can change. The following GUD are read in:
● ROCO_TC_FLANGE
● ROCO_TC_COG
● ROCO_TC_INERTIA
● ROCO_TC_MASS
● ROCO_TOOL_MASS
● ROCO_ADD_MASS
SINUMERIK Run MyCC /ROCO
Function Manual, 09/2018, A5E45818879B AA
<n> is a freely selectable integer number between 1 and
999999
<c> is the channel number in which this file should be read
in.
Meaning
The file number is used to select to the configuration file. The permissible range
lies between 1 and 999999.
; Deactivate the function
; in the 1st channel: Read in ROCO1_CH1.DAT configuration file

7.3 Function CC_ROCOREREAD

Functions
31