Table of Contents
Advertisement
INSTALLING THE HYDRO KIT
Unpack / Inspect, Transporting / Lifting
Unpack the Hydro Kit / Inspect for Damage
1. Before opening, check the unit model number on the box. Verify it is the correct capacity, unit type and voltage. Refer to the Nomenclature
Chart in this manual.
2. Place the box on a solid surface right side up.
3. Cut the white reinforced nylon straps.
4. Open the top of the box and fold back all four flaps.
5. Remove the protective cardboard.
6. The walls and top panels are not attached to the bottom of the box. Lift the cardboard carton by the flaps and remove the box walls and
top and place it to the side.
7. Remove the moisture barrier plastic bonnet.
8. Check the unit nameplate data and model number. Verify the unit voltage, and capacities are correct before proceeding.
9. Remove and retain the installation manual. It is located under the unit, on top of the unit, or taped and inserted inside the unit cabinet.
10. Lift the unit (not by refrigerant piping) and inspect for freight damage. If damage is found, repack the unit as it was received in the original
container.
Transporting / Lifting
• Refer to the table below for accurate weights before transporting or lifting.
• When lifting the unit, use lifting straps and place around the unit as shown.
• Always lift the unit using properly sized lifting straps rated to carry the unit
weight.
• Ensure the straps are long enough to maintain a maximum of a 40° angle as
shown at "A".
Table 11: Hydro Kit Chassis Net and Shipping Weights.
Chassis
ARNH423K2A4
ARNH963K2A4
22
Net Weight (lbs.)
Shipping Weight (lbs.)
67
77
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
Figure 2: Proper Transportation of Unit.
A:
79
B:
89
A
A
l
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
