Huawei SUN2000-4.95KTL-JPL0 Quick Manual page 22

Category Status (Blinking slowly: On for 1s and then Off for 1s;
Blinking fast: On for 0.2s and then Off for 0.2s)
Run LED1
indication
Steady green
Blinking green at long
intervals
Blinking green at long
intervals
Off
Steady red
Communic LED3
ation
Blinking green at short intervals
indication
Off
System Commissioning (SmartLogger1000A WebUI)
1. Use the SmartLogger1000A to set parameters for the SUN2000-4.95KTL-JPL0.
2. Operating system: Windows 7 or later versions
3. Browser: Chrome 52, Firefox 58, Internet Explorer 9, or their later versions
4. The WebUI snapshots are for reference only, and the actual display prevails.
1
Preparations and WebUI Login
1. Connect the network cable between the network port on the PC and the ETH port on the
SmartLogger1000A.
2. Set the IP addresses of the PC and SmartLogger1000A in the same network segment.
Item
IP address
Subnet mask
Default gateway
LED2
Steady green
Off
Blinking green at long intervals
Off
Steady red
SmartLogger Default Value
192.168.0.10
255.255.255.0
192.168.0.1
Example PC Setting
192.168.0.11
255.255.255.0
192.168.0.1
21
Description
N/A
The solar inverter operates in
the grid-tied mode.
The DC is on and the AC is
off.
Both DC and AC are on, and
the solar inverter is not
connected to the power grid.
The DC is off, and the AC
may be energized (Ensure
that the external AC switch is
OFF).
Fault
N/A
The solar inverter is in
communication.
No communication