14
FIXING THE ANCHORS AND SCREWS
FIXING THE ANCHORS AND SCREWS
Fixing the anchors and screws
CAUTION
Check the wall material and thickness of the finish material.
y
You can use the included anchors and screws with the screen for walls made of
y
concrete, lightweight concrete, soft fieldstone, hard fieldstone, brick, or hollow blocks.
If you want to install the product on another type of wall not previously listed, make
y
sure the wall can withstand a load of 686 N (70 kgf) per part and a shear load of
980 N (100 kgf) or more.
(Layer reinforcing materials such as plywood over the wall and then install the
product on top.)
a. Drill a hole with a diameter of 80-100 mm where the anchor will be attached to using
an 8 mm drill bit.
b. Clean out the drilled hole.
c. Insert the enclosed anchor into the hole. (Use a hammer when inserting the anchor.)
d. Insert the component into the hole and tighten it.
Tighten the screw using a recommended torque of 45 - 60 kgf/cm or more.
a
Drilling
c
Anchor insertion
Ring and steel spacer attaching screw
d
Attaching ring and steel spacer
Anchor
Attaching ring and steel spacer
b
Hole cleaning