Sony CXD5602 User Manual page 160

3.5.3 Analog Circuits
The CRG has three analog circuits (RCOSC block, XOSC block, and SYSPLL block). The following shows the
setting confirmation registers of each analog circuit. Some of them are RW registers, but use them as RO registers.
For descriptions of the RF block, refer to Section 3.12.
3.5.3.1 RCOSC Block Setting Confirmation
The RCOSC is an internal ring oscillator that operates at 8.192 MHz. In initial state, the oscillation frequency is
higher than 8.192 MHz, but by using the calibration process of the API, it can be adjusted to 8.192 MHz.
3.5.3.1.1 Register Descriptions
Table Clock and Reset (Clock Reset Generator)-51 shows the control registers related to the RCOSC block.
Table Clock and Reset (Clock Reset Generator)-51 RCOSC Block Status Registers
Address Register
Name
0x04100590 RCOSC_
CTRL1
3.5.3.2 XOSC Block Setting Confirmation
The XOSC operates at the following 5 frequencies. The selectable frequencies are different between internal
oscillation and external clock input mode.

Frequency
26 MHz

Mode

Internal oscillation mode (system configuration using crystal oscillation)
*Supported frequencies: 26 MHz

External clock input mode (system configuration using TCXO)
Bit Field Type
Name
Reserved RW
IRO_LV_SENSCLK_ RW
XEN
IRO_LV_LOGICLK_ RW
XEN
Reserved RW
－160/1010－
Bit Initial Description
Value
[31:15] 0 Reserved
[14] 1
Indicated as ANA(1) in
Reset (Clock Reset Generator)-34
Clock Enable for HPADC
0: Enable, 1: Disable
[13] 0
Indicated as ANA(0) in
Reset (Clock Reset Generator)-34
Clock Enable for each function block
0: Enable, 1: Disable
[12:0] 1 Reserved
CXD5602 User Manual
Figure Clock and
Figure Clock and