Layout/Position Adjustment Commands; File Settings: Alc - Panasonic LP-GS Series Serial Communication Command Manual

3-10 Layout/Position Adjustment Commands

3-10-1 File settings: ALC

Adjusts the marking position and layout for each file. These settings are applied to all marking data in the selected file.
• "Number of overwritings" and "Overwriting interval" settings by this command are applied to the object group No. 1000.
To the object group No. 1000 the marking data converted from LP-400/V files and the data set by LP-400/V compatible
command mode belong.
• With LP-400/V compatible command mode, Z-movement cannot be set.
• When the setting value of the number of overwritings is more than 100, it is not possible to readout the setting by this
command.
⿎ Setting request data / response data for readout
Start Sub
ALC
code command
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
ALC
code
⿎ Data description
Name Data length
(> Name in LP-400/V)
X-movement
Y-movement
Rotation movement
Number of
overwritings
Overwriting interval
Y-axis mirroring
X-axis mirroring
Proportional type *
(> Kerning)
Total data length
* This item can be omitted.
[X-movement] [Y-movement] [Number of overwritings]
[Overwriting interval] [Rotation movement]
[Y-axis mirroring] [X-axis mirroring] [Proportional type]
R (Check sum)
Data contents
[byte]
8
"-999.999"–"+999.999" [mm]
8
7 "-180.00"–"+180.00" [°]
2 "01"–"99" [times]
"0.0"–"9.9" [s]
3
"000"–"060" [s]
"0": Do not invert
1
"1": Invert
"0": Do not invert
1
"1": Invert
"1": Proportional 1
(1) "2": Proportional 2
"3": Proportional 3
Fixed length.
31 • When Proportional type is not omitted: 31-byte
(30) • When Proportional type is omitted: 30-byte
• Response data for readout: 31-byte
ME-LP-GS-SR-COMP-3
31-byte or 30-byte
End code
• Moves the coordinate of the all marking
data in the file.
• The rotation center is the center of the
marking field.
When on-the-fly marking is set, set always 0
second to overwriting interval.
It is an inversion to Y-axis.
It is an inversion to X-axis.
• When "proportional" is set to the character
spacing type in the character object
settings, select the level of spacing. The
lower the number is, the smaller the
spacing is.
• When this item is omitted, the data set
last (the initial value if it was not set) is
maintained.
(Check
End code
sum)
Remarks
113