Configuring The Ip Address And Routing Information Of The Bts; Figure 3-6 Connection Between The Ws And The Bckm - Huawei Airbridge BTS3606E Commissioning Manual

Airbridge BTS3606E&3606AE
System Commissioning Guide
Step 1 Use a crossover Ethernet cable to connect the Ethernet port of the WS and that of the BCKM.
Figure 3-6 shows the connection between the WS and the BCKM.

Figure 3-6 Connection between the WS and the BCKM

Network
Step 2 Click Start > Run.
Step 3 In the Run dialog box, execute the command cmd.
The Command window is displayed.
Step 4 In the Command window, execute the command Ping xxx.xxx.xxx.xxx to verify the
connectivity between the WS and the BTS.
Step 5 If the connection proves to be successful, execute the command Telnet xxx.xxx.xxx.xxx to
log in to the BTS.
If the computer fails to access the BCKM, the possible causes are as follows:
----End
3.3.3 Configuring the IP Address and Routing Information of the
BTS
Task Description
Configure the IP address and routing information of the BTS that uses IP over FE
transmission.
Prerequisites
Issue 02 (2006-10-10)
port
Crossover
Ethernet cable
BCKM
BTS
The IP address of the BCKM Ethernet port is 172.16.16.16 by default.
The crossover Ethernet cable is faulty.
The IP address of the WS is wrong.
You need to carry out this task only when the BTS uses an FE link to bear the IP connection and when
the BTS is started for the first time.
The WS is in the same TCP/IP network as the BCKM.
The communication between the WS and the BCKM is normal.
Huawei Technologies Proprietary
3 Commissioning Process
3-11