Error Messages In Setup Mode - Panasonic AK-HRP200G Operating Instructions Manual

Setup.Mode.Operations.
2..
Press.<UP>.or.<DOWN>.to.select.the.setting.number,.
and.press.<EXECUTE>.to.confirm.the.selection.
ND
M.GAIN
• To make other settings, press <SELECT> to select a menu number.
Error.messages.in.setup.mode
Error.No.
E01 A file with the same name already exists. Select [y]
to overwrite.
E02 An error occurred on the memory card.
• Check if a file exists.
• Check if the memory card is write protected.
• Check if there is any free space left on the memory card.
• Check if an SDXC card is being used.
• The file format of the memory card may not be
correct.
• There may be a memory card format abnormality.
E03 A memory card has not been inserted.
E04 • A communication error occurred. Check the
connected equipment.
• The lens file is off.
• There are not connections with cameras and CCUs
and the control privileges are disabled. (For details
on control privileges, refer to Operating Instructions
<Basics>.)
E05 An error occurred. Start over from the beginning.
„ When.a.file.with.the.same.name.exists.on.the.memory.card
„
[E01] is displayed when a file with the same name as the one you are
attempting to save already exists on the memory card.
To overwrite the file, press <UP> or <DOWN> to select [y] and press
<EXECUTE>.
„ When.E02.to.E05.are.displayed
„
Press <EXECUTE> to close the error message. Then perform the
operation again.
20
(continued)
CC SHT SYNC
M.PED
IRIS
Error.data