Control Connections; Frame R2I To R5I; Frame R2I To R4I (R3I Pictured) - ABB ACS800 Hardware Manual

Control connections

Frame R2i to R5i

These inverter modules have a built-in RMIO (Motor control and I/O) board. For
descriptions of the terminals, see the chapter

Frame R2i to R4i (R3i pictured)

The control cable connection
terminals are exposed when the
control panel platform (if present) is
turned aside by pulling this lever. Be
careful – do not use excess force
I/O cables: Ground the
control cable shields in the
holes with screws. See
degrees grounding of I/O
cables on page
when pulling.
360
63
Prevention of unexpected start
(optional) – see Frame R2i to R4i
power connections on page
Motor control and I/O board
Detachable I/O terminals (pull upwards)
53
63
(RMIO).
RMIO X39 for control
panel cable
Optional module 1
Optional module 2
DDCS communication
option module 3:
RDCO
Install shroud
(included) on the relay
outputs if voltage at the
terminals exceeds
50 V AC