Panasonic U-8ME1E81 Service Manual page 104

1. Outdoor Unit Maintenance Remote Controller
Setting mode 2
Press and hold the
(SET) button and the
simultaneously for 4 seconds or longer.
Press the temperature setting
buttons to change the item code. The item codes
and setting data are shown in the table below.
Press the timer time
change the setting data.
To confirm the changed setting data, press the
(SET) button.
(At this time, the "
and remains lit.)
During this mode, "
blinking. The display shows the set outdoor unit
address "System XX-YY" (System XX = System
address, YY = Address at outdoor unit sub-bus),
1
item code number (DN value in the table below),
and the setting data (6 digits).
(The setting data is displayed in 6 digits. The
display changes between the first 3 digits
(Fig. (C)) and the last 3 digits (Fig. (D)). When the
first 3 digits are displayed, the bottom point of the
2
colon is illuminated.)
To exit setting mode, press the
button. Returns to normal display mode.
3
4
5
6
List of Item Codes
CODE
Parameter
NO.
7
Outdoor unit capacity
8
(CHECK) button,
(CANCEL) button
and
and buttons to
" display stops blinking
" is displayed,
(CHECK)
Description (SET DATA)
000 Disabled
224 Type 8HP
280 Type 10HP
335 Type 12HP
5
1
(C) Display of first 3 digits
5
1
(D) Display of last 3 digits
Refrigerant type: (C) and (D) are displayed alternately.
Example shows 000, 410 (R410A).
400 Type 14HP
450 Type 16HP
500 Type 18HP
560 Type 20HP
6-10
2WAY SYSTEM
Service Checker
2
3
2
3