Getting Started; Intended Use; Hardware Overview; Main Components - Bosch XDK110 General Information Manual

! !

1. Getting Started

1.1 Intended Use

The XDK110 Cross-Domain Development Kit is a prototyping platform for Internet of Things (IoT)
use cases. It works with Windows 7 or higher.

1.2 Hardware Overview

1.2.1 Main Components

MCU: 32-bit microcontroller ARM Cortex M3 EFM32GG390F1024 (Silicon Labs)
•
Communication interface
•
o Bluetooth Low Energy
o Low power IEEE 802.11b/g/n WLAN
Inertial sensors (9DOF)
•
o Accelerometer: BMA280 (Bosch Sensortec)
o Gyroscope: BMG160 (Bosch Sensortec)
o Magnetometer: BMM150 (Bosch Sensortec)
o Inertial measurement unit BMI160 (Bosch Sensortec)
• Environmental sensors
o Combined humidity / temperature / air pressure sensor: BME280 (Bosch Sensortec)
o Ambient light: MAX44009 (Maxim Integrated)
o Microphone for noise detection: AKU340 (Akustica)
Internal Li-Ion rechargeable battery, 560 mAh capacity
•
• Integrated antennas
User interface:
•
o 3 programmable status LEDs
o 2 programmable push-buttons
o Micro SD card
o J-Link debug interface
o Interface for extension board

1.2.2 Included Deliveries

Device in its housing, with built-in lithium ion rechargeable battery
•
"XDK Gateway" extension board for easy access to additional MCU functionality, incl.
•
connector cable
Micro USB 2.0 connector cable
•
Mounting plate and screws
•
1 Micro SD card not included
2
L-Link debug adapter needed, not included; see JTAG Debug Interface
XDK110
© Bosch Connected Devices and Solutions GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as
copying and passing on to third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
General Information Guide XDK110 General Information Guide XDK110
1
‑
2
‑
Page ! 5 Page ! 5
BCDS