Creating The Configuration File - Siemens SINUMERIK 840DE sl Commissioning Manual

11/2006
8.10.3

Creating the configuration file

Syntax
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill - - 11/2006 Edition
You must store all the changes you have made to the lists from the default set-
ting in the TO_MILL.INI configuration file.
Please note the following:
After the column "DP number" you can define further columns and also hide
S
existing columns.
S The number of columns displayed is limited by the width of the window be-
cause each column has a fixed width. Horizontal scrolling is not possible.
Per column define cutting edge parameters only, tool parameters only, or
S
magazine parameters only.
Define the cutting edge parameters in consecutive columns.
S
The sample file TO_MILL.INI, which can be adapted, is located in
ShopMill on NCU (HMI Embedded) under
CYCLE_STORAGE\SEQUENCER_CYCLES\TEMPLATES_DEU.
The adapted file is then found on the CF card (NCU 7x0) under
-- oem\sinumerik\hmi\cfg\
-- user\sinumerik\hmi\cfg\.
For ShopMill on PCU 50.3, this example is located on the supplied CD under
Tools\TEMPLATES_DEU.
The file is copied to the directory OEM or USER.
Entries in the configuration file are subject to the following syntax rules; (see
also example at end of this section):
First specify in which tool management list you would like to make changes.
[DISPLAY_IDENTIFIER]
DISPLAY_IDENTIFIER: Tool management list
8 Tool Management
8.10 Configuring the operator interface
8-111