Viewing A List Of Users; Adding A User; Deleting A User - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
• Section 4.9.2, "Adding a User"
• Section 4.9.3, "Deleting a User"
• Section 4.9.4, "Monitoring Users"
Section 4.9.1

Viewing a List of Users

To view a list of user accounts, type:
show running-config admin users
If users have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin users | tab
admin
users
userid
NAME PASSWORD
----------------------------------------------------------
admin $1$LmRO$j7/q/wtlwjfUvbOVrbt4o.
guest $1$uGztU0$6b7YS6gqwtrelTzA/2noQ.
oper $1$eSsFfFMh$NEHgTHsU1T4RRz8sXNV2F1
If no user accounts have been configured, add user accounts as needed. For more information, refer to
Section 4.9.2, "Adding a
Section 4.9.2

Adding a User

To add a new user account, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the user account by typing:
admin users name name role role
Where:
• name is the name of the user account
• role is the role of the user. The options are administrator, operator, and guest.
3. To set the user password, follow the instructions in
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 4.9.3

Deleting a User

To delete a user account, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the user account by typing:
Viewing a List of Users
ROLE
administrator
guest
operator
User".
Section 4.10.2, "Setting a User
Chapter 4
System Administration
Password/Passphrase".
179