Table of Contents
Advertisement
Indications in [
] of each item mean as follows:
(Example) Stop operation of data link [HEX (hexadecimal), byte]
This means to set "stop operation" by hexadecimal and byte unit.
Turn "ON" the power of slave station PC
Connect support tools
Connect a support tool with the JW-21MN.
<Usable support tools>
JW-14PG/13PG/12PG
JW-50SP
JW-50PG, Z-100LP2S
- For operation of each support tool, see the instruction
manual attached. The following describes an example
of JW-14PG's key operation.
Note: Setting parameters is unavailable by JW-2PG.
Stop PC operation
Turn to program mode (stop PC operation). Setting of parameters is only available when the PC is
in program mode.
Select parameter setting mode.
Select initial mode
Stop operation of data link
Write "00
" to parameter address 007777
(H)
of the JW-21MN. Setting of the parameter is only available
when the operation of the JW-21MN is stopped.
Display the contents of parameter
address 007777 by hexadecimals.
Reference Function of JW-14PG
-
key: Changeover unit of figures
-
key: Byte display
To the next page
Stop PC operation
(Set parameter)
[HEX (hexadecimal), byte]
and stop operation
(8)
（ ）
Write
.
00
(H)
→
→
OCT (octal)
HEX (hexadecimal)
Changeover word display
←→
11-25
(JW-14JG)
007777
Screen display of JW-14PG
07775
HEX
00
07776
HEX
1F
I PARAM.
>07777
HEX
00
→
→
DCM (decimal)
Bit pattern
JW-21MN
0 0
(8)
(H)
11
Advertisement
Table of Contents
