Reset Radius Statistics; Reset Stop-Accounting-Buffer (For Radius) - HP A-U200 Command Reference Manual

authentication-server-down: Sends traps when the reachability of the authentication server changes.
Description
Use the radius trap command to enable the trap function for RADIUS.
Use the undo radius trap command to disable the trap function for RADIUS.
By default, the trap function is disabled for RADIUS.
With the trap function for RADIUS, a NAS sends a trap message in the following cases:
• The status of a RADIUS server changes. If a NAS sends a request but receives no response before
the maximum number of attempts is exceeded, it places the server to the blocked state and sends
a trap message. If a NAS receives a response from a RADIUS server it considered unreachable, it
considers that the RADIUS server is reachable again and also sends a trap message.
The ratio of the number of failed transmission attempts to the total number of authentication request
•
transmission attempts reaches the threshold.
Examples
# Enable the device to send traps in response to accounting server reachability changes.
<Sysname> system-view
[Sysname] radius trap accounting-server-down

reset radius statistics

Syntax
reset radius statistics
View
User view
Default level
2: System level
Parameters
None
Description
Use the reset radius statistics command to clear RADIUS statistics.
Related commands: display radius statistics.
Examples
# Clear RADIUS statistics.
<Sysname> reset radius statistics

reset stop-accounting-buffer (for RADIUS)

Syntax
reset stop-accounting-buffer { radius-scheme radius-scheme-name | session-id session-id | time-range
start-time stop-time | user-name user-name }
View
User view
106