Page 1
LCD PROJECTOR LENS MODEL NO. LNS-S02Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector.
Page 2
NOTES ON LENS INSTALLATION • Lens installation and replacement should be made by the qualified service personnel. • Be sure to install the lens following this procedure precisely. • The lens cover is on the lens for protection. Be sure to replace the lens cover before installation.
Page 3
LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps REMOVE THE LENS COVER. (See figure-1) 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it. 3. Remove screws B (2 screws). 4.
Page 4
❋ Figure shown inside of the cabinet. INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) Install the light-block sheet around the lens as shown in the illustration. (Use the sheet included with the lens.) Set the light-block sheet, so that the large rounder side is set over the lens.