Installing Hp 3Par Os Files - HP 3PAR StoreServ 7000 Service Manual

NOTE:
(page 62).
24. Monitor the system while the SP uses the site key. When the system communications
configuration is complete, the following message appears:
(....)
*** starting final MOB phase
Updating PAM settings
Rebooting....
The SP restarts.
Continue to

Installing HP 3PAR OS Files

After completing the Service Processor Setup wizard process, HP 3PAR OS files must first be
installed onto the SP in order to communicate and add a storage system.
To install the OS files:
1. Insert the HP 3PAR OS Release Distribution CD into the SP.
2. Log in to the SP as spvar (password prompted).
3. In the SPMaint main menu, type:
1 for SP Control/Status
16 for Maintain SP Software
1 for Update SP Software Revision
2 for CDROM to install the files.
NOTE:
4. When prompted to update the SP, verify that the software version is correct. Type y and press
ENTER to continue with the update process.
Mounting CDROM...
Using spinstaller from /sp/sw/sp/2.5.1.GA-15/
(y or n)
y
5. When the installation process completes, the SPMaint main menu reappears. To verify the
current software versions after installation, type 1 for SP Control/Status.
1
To add a storage system, see
Fix passwords
enabling key change...
Disabling sendmail...
verifying postfix status...
Setup to run all ST/SP tasks at boot time
Cleanup MOB
"Installing HP 3PAR OS Files " (page
The installation process takes approximately five minutes.
tpdSPInFormOS3.1.2.226-3.1.2.226-12.i386.rpm
Do You wish to update the SP from /mnt/cdrom?
SP Main
3PAR Service Processor Menu
Transfer media: ethernet
"Adding a Storage System to the Service Processor"
61).
Transfer status: Ok
Installing HP 3PAR OS Files 61