Configuring Ospf Area And Network On A Layer 3 Device - Siemens RX1400 Reference Manual

Chapter 7
Examples
</lock>
</rpc>]]>]]>
4. Configure the <ip-address-src> setting for the port:
<rpc message-id="233" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config>
<interface xmlns="http://ruggedcom.com/ns/rmf_if">
<eth>
<slot>lm4</slot>
<port>1</port>
<ip-address-src>dynamic</ip-address-src>
</eth>
</interface>
</config>
</edit-config>
</rpc>]]>]]>
5. Commit the changes:
<rpc message-id="234" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<commit/>
</rpc>]]>]]>
6. Unlock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="235">
<unlock>
<target>
<candidate/>
</target>
</unlock>
</rpc>]]>]]>
7. Unlock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="236">
<unlock>
<target>
<running/>
</target>
</unlock>
</rpc>]]>]]>
Section 7.25
Configuring OSPF Area and Network on a Layer 3
Device
In this example, multiple <rpc> requests configure OSPF area and network in the candidate configuration and
then commit the changes.
The following is the recommended procedure for making configuration changes on a device.
1. Lock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="230">
100

Configuring OSPF Area and Network on a Layer 3 Device

RUGGEDCOM NETCONF
Reference Guide