Table of Contents
Advertisement
Installation & Operation Guide
OPERATION
The LightPack LED Module will power up when the AC power is connected. (NOTE: the
LightPack LED Module does not have a main on/off switch.)
The LightPack LED Module provides two LED status indicators and a Focus/Bump buttons.
LightPack LED Controller - Status LED Indicators
The two LEDs associated with each channel report various operating conditions.
Red LED
On
Off / On
Focus / Bump Button Operation
Once each luminaire has been set up, tap the Focus / Bump button once to turn on all of the
LEDs on the attached luminaire. Each successive Button tap will advance through each LED
color that the Luminaire offers. The final tap will turn the luminaire off.
Button Tap
1
2
3
4
5
6
7
Luminaire Discovery
The LightPack LED Module is set, by default, for RGBAW LED luminaire operation. If you
plug in an RGB or WW LED luminaire, you will need to cycle through the Focus / Bump
button presses (as described in "Focus / Bump Button Operation") to return to the first color.
The LightPack LED Module can "discover" and set itself to control the type of connected
luminaire.
To Discover the connected luminaire:
Step 1. Connect luminaire to LightPack LED Module. Note, LightPack LED Module must
be powered.
Step 2. Press and hold Focus / Bump button for 5 seconds.
Step 3. The luminaire will flash through all colors and stop.
Step 4. The LightPack LED Module is now set to connected RGB or WW luminaire.
8
Green LED
Off
On
RGBAW Luminaire
All On
Red
Green
Blue
Amber
White
Off
Condition
No DMX512 Communications
Module is set to 100% by Focus / Bump button
RGB Luminaire
All On
Red
Green
Blue
Off
LightPack LED Module
WW Luminaire
All On
Warm White
Cool White
Off
Advertisement
Table of Contents
