30
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the M723 «Spacing clamps» motor (next):
Replacement of the carbon brush:
1. Remove the splash guard.
2. Disconnect the wire of the motor.
3. Remove the transmission belt and the drive pulley.
5. Remove the motor and the motor bracket (fi g.1).
6. Remove the protection of the carbon brush using a screwdriver (fi g.2 and 3).
7. Extract the carbon brush and replace it by a new one (fi g.4 and 5).
8. Close the protection of the carbon brush.
9. Put back the parts in the reverse sequence.
fi g.1
fi g.4
8
Feeding: Motion
(electricity, steam, water, gas, compressed air...).
fi g.2
fi g.5
Service
Manual
fi g.3
04102011/GB
21-2012