D-Link DCS-820L Quick Install Manual page 8

1. The Image is out of focus.
You can turn the white focus ring on the front of the camera to adjust the focus.
2. How do I change the accent rings?
Rotate the accent ring counterclockwise, then lift it off. Put the new ring on and rotate
it clockwise until it clicks into place.
3. I started the mydlink Baby Camera Monitor app, but I can't find my camera.
• Make sure your camera is turned on and receiving power.
• If you are setting up a new camera, make sure your smartphone or tablet is
connected to the camera's Wi-Fi signal (not your wireless router).
• The Wi-Fi network name should be [myBabyCam-XXXX], where XXXX is a 4-digit
code (the last four digits of your camera's MAC address).
• The Wi-Fi network name and password is printed on a label on the bottom of your
camera and on the back of this install guide.
• If you still can't find your camera, reset your camera by pressing its reset button for
10 seconds (while it is powered on).
4. Why is there a white haze when viewing in night vision mode?
The night vision lights on the camera may be reflecting off a nearby surface. Try
repositioning and aiming the camera.
5. How can you power the camera?
The camera can be powered with the provided power adapter or you can use an
external USB battery for total portability. (USB battery is not included. Requires 5V/2A
output.)
6. How do I access the camera remotely?
You can set up a new mydlink account and register the camera with mydlink services
during the initial setup. Once the process is complete, log in to your mydlink account
by tapping the mydlink Login button on the Home screen. With mydlink, you can
monitor your baby from anywhere as long as your smartphone or tablet is connected
to the Internet (over Wi-Fi or over the cellular network).
Note: If you don't enable mydlink services, you will only be able to view the camera within your
home's wireless coverage area.
FAQs
8