Table of Contents
Advertisement
Chapter 9 Symbologies
Introduction
This chapter describes symbology features and provides the programming bar codes for selecting these features.
Before programming, follow the instructions in
The decoder is shipped with the settings shown in the
Standard Default Parameters
requirements, programming is not necessary.
There are two ways to change a parameter value:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a "parameter send" command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer's
Guide for detailed instructions for changing parameter values using this method.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
To return all features to default values, scan
code menus, default values are indicated with asterisks (
Chapter 1, Getting
for all host device and miscellaneous defaults). If the default values suit
Set Default Parameter on page
*
Enable UPC-A
*
Indicates Default
Started.
Symbology Default Table on page 9-2
4-4. Throughout the programming bar
*
).
Feature'/Option
(00h)
(also see
Appendix A,
Advertisement
Table of Contents
