Bosch Solution 2000 User Manual page 27

Control Panel
Term
hand-held radio
remote control
isolate
master code
monitoring station
panic
sealed
sensor watch
silent alarm
STAY Mode 1
STAY Mode 2
telco arming
sequence
telco disarming
sequence
unsealed
user code
zone
Tab. 6.11: Glossary of Terms
Bosch Security Systems, Inc.
Description
A device used to arm and disarm a security system or to cause a panic
alarm.
A method of manually disabling (isolating) one or more zones before
arming the system.
A numeric code used for allowing those users that have the appropriate
priority level to perform certain supervisory level functions.
A secure location where a digital receiver monitors a number of alarm
systems and deciphers their alarm transmission reports so the operator
can advise the appropriate authorities to take immediate action.
A condition or type of alarm in which the user requires either immediate
police or medical assistance.
Refers to a zone's status. If a zone is sealed, the detection devices are
not violated and the zone indicator is not lit (that is, a reed switch is
closed or a detector is on standby waiting for an intrusion).
A feature that allows the control panel to recognize when detection
devices might have stopped working. Sensor watch monitors the
operation of a zone over a programmed time period.
An alarm that sounds only at a remote location, and gives no obvious
local indication that an alarm was sent out.
A condition that automatically isolates certain zones when the security
system is armed in this mode. Only the installer can program these
zones.
A condition that automatically isolates certain zones when the security
system is armed in this mode. The Master Code holder can program
these zones.
A feature that automatically diverts a telephone number to another
telephone when a security system is armed in AWAY Mode, the same as
using call forwarding.
An automatic suspension of diverting of the telephone when the system
is disarmed.
Refers to a zone's status. If a zone is unsealed, the detection devices
are violated and the zone indicator is lit (that is, a reed switch is open
or a detector noted an intrusion).
A numeric code used to arm and disarm the system.
A monitored input used to activate an alarm. A zone might be set up to
activate an alarm only when the system is armed or to operate whether
the system is armed or disarmed.
User's Guide
Glossary of Terms | en 27
2017.09 | 04 | F.01U.298.028