Removing The System For Servicing; Figure 6-3 Support Brackets - HP A1896A Installation Manual

Removing the System for Servicing

If it is necessary to remove the system from the cabinet for further servicing, follow these
steps:
1. Remove any cables attached to the rear of the system.
NOTE Tag the cables, if necessary.
2. Remove the three screws shown by callout (1) in Figure 6-3. Remove the pivot support
bracket.
3. Remove the eight screws shown by callout (2) in Figure 6-3. Remove the fixed support
bracket.

Figure 6-3 Support Brackets

Chapter 6
System Servicing
Removing the System for Servicing
6-3