Installing The Expansion Board And Iwus - Samsung DECT 500 Installation And Programming Manual

Part 2: DECT Hardware Installation & Programming

Installing the Expansion Board and IWUs

The CCFP expansion board has to be mounted in the CCFP if more than eight RFPs
are needed. The expansion board handles up to eight RFPs besides the eight RFPs
the CCFP main board handles (maximum 16 RFPs).
The CCFP needs the FLASH software PCS3 or later edition to control the expansion
board. If the CCFP has an older software version it is necessary to upgrade the sys-
tem. Upgrade software is not included in expansion kit (PN 13816).
1. Disconnect the CCFP from its power supply.
2. Remove the top cover.
3. Remove the blind cover plates.
4. Mount the expansion board on the CCFP by inserting the two plastic pins (Figures
2.2 and 2.3).
5. Insert the IWUs starting at slot no. 0 (Figure 2.2).
Figure 2.3 Mounting Expansion Board
5. Mount the expansion board internal cable in place of the blind covers (Figure 2.4).
Expansion Board Rear Panel
Figure 2.4 Internal Cable
27