HP Designjet 3D Service Manual page 378

1 1. Next measure and record the distance from the outside edges of circle B
12. Add the lengths derived from steps 5 and 6 (A-B and B-C) and then sub-
13. Measure and record the distance from the outside edges of circles E and
-362
Figure 357: Measuring distance from outside edges of A and B
and C, see Figure 358 Ensure that the caliper is not seated on the small
bump of circle C.
Figure 358: Measuring distance from outside edges of B and C
tract the width of circle B. Record this total as "GFront"
F. Ensure the caliper is not seated on the small bump of circle E. See
ure 378
Figure 359: Measuring distances from outside edges of C and F
Fig-