Toshiba MML-AP0124H2UL Service Manual page 22

No. Item
5 Fan speed <HEAT>
selection
(Continued)
(– 0.9) – 1.8 [(– 0.5) – 1.0]
Value in the parentheses indicates one when thermostat of
the remote control works.
Value without parentheses indicates one when thermostat of
the Indoor unit works.
• If the fan speed has been changed once, it is not changed
• When heating operation has started, select an upward
• If the temperature is just on the margin the fan speed does
• In TC2
6 Prevention of 1. In heating operation, the higher temperature of TC2 sensor
cold air
discharge
Outline of specifications
TA ˚F (˚C)
(0) Tsh
(+0.9) +1.8 [(+0.5) +1.0]
(+1.8) +3.6 [(+1.0) +2.0]
(+2.7) +5.4 [(+1.5) +3.0]
(+3.6) +7.2 [(+2.0) +4.0]
Indoor unit thermostat works.
Remote control thermostat works.
for 1 minute. However when the air volume changes, the
fan speed changes.
slope for the fan speed, that is, the high position.
not change.
140°F[60°C], the fan speed increases by clarify 1
step.
and TCJ sensor is compared with temperature of TC1
sensor and then the lower temperature is used to set the
upper limit of the fan tap.
• When B zone has continued for 6 minutes, the opera-
tion shifts to C zone.
• In defrost time, the control point is set to +10.8°F[6°C].
°F (°C)
90 (32)
D
86 (30)
C E
82 (28)
75 (26)
68 (20)
61 (16)
L <L>
L <H>
H <H>
H
<HH>
HH
<HH>
< > : Indicate automatic heating.
A zone: OFF
B zone:
Over 72°F (26°C), below 82°F (28°C), ULTRA LOW (LL)
C zone:
Over 82°F (28°C), below 86°F (30°C), LOW (L)
D zone:
Over 86°F (30°C), below 90°F (32°C), MED (H)
E zone: HIGH (HH)
B
A
– 22 –
Remarks
E
D
C
B
A
TC2: Indoor heat
exchanger sensor
temperature
TCJ: Temperature of
indoor heat
exchanger sensor
TC1: Temperature of
indoor heat
exchanger sensor
• In D and E zones,
priority is given to
remote control air
speed setup.
• In A zone "
played.
" is dis-