Select Diag Mon Test
O2 Sensor B1S1
O2 Sensor B1S2
Catalyst B1
Purge Flow Mon
HO2 Sen B1S2
Misfire Data
Misfire Cyl 1
Misfire Cyl 2
Misfire Cyl 3
Rd\Er
Or, refer to appropriate vehicle service manual for
test IDs and definitions.
•
On Non-CAN vehicles the scan tool displays:
–
Test data (test ID)
–
Maximum value (MAX)
–
Test measurements (MEAS)
–
Minimum value (MIN)
–
Status (STS)
–
Measurements and Specification values are
hexadecimal numbers (i.e., $1A, $FE, $11.)
–
Module (MOD)
Test $03
ID
MOD
MAX
MEAS
MIN
STS
Rd\Er
•
On CAN vehicles scan tool displays:
–
Test performed. The test performed can be
$## if test is not defined. Refer to vehicle
service manual for details.
–
Measured values and units of measured
(such as volts, amps, and seconds).
–
Status of monitor test data.
–
Module ID where the monitor test data
came from.
Purge Flow Mon
Test
MOD
MAX
MEAS
MIN
STS
Rd\Er
3.
Return to Select Test menu.
•
Press
.
4.
Return to Diagnostic Menu.
Bosch Automotive Service Solutions Inc.
01
$09
----
00
00
OK
$C9
$00
32.767(KPa)
0.110(KPa)
0.000(KPa)
OK
OBD 2220 Info Scan | User guide | 29 | en
•
Press
.
5.12
On-Board Systems
The On-Board Systems test allows the scan tool to con-
trol operation of vehicle components, tests or systems.
•
Some manufacturers do not allow tools to control
vehicle systems. A vehicle not supporting an on-
board system is identified by a message that is
displayed when selected.
•
Refer to the vehicle service manual for on-board
systems instructions.
•
The manufacturer is responsible for determining the
criteria to automatically stop test. Refer to appropri-
ate vehicle service manual.
From Diagnostic Menu:
1.
Select On-Board Systems.
•
Use the
and
tems is highlighted.
•
Press
.
Diagnostic Menu
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Charging System Monitor
Rd\Er
•
A list of on-board systems and components
available for testing are shown on the display.
2.
Select test.
•
Use the
and
highlighted.
•
Press
.
On-Board Systems
EVAP Systems Test
Rd\Er
3.
Return to On-Board Systems menu.
•
Press
.
4.
Return to Diagnostic Menu.
keys until On-Board Sys-
keys until desired test is
580000 | REV. A | 04.2017