2 Registering the Repeater
ID Modification
In ID Modification mode, the ID of the repeater (RPN [Radio Part Number]) can be selected. Registered
repeaters are automatically assigned an ID during the registration process. This ID can be changed by following
the procedure below.
1.
In Operation mode, or Easy Registration mode if the repeater is unregistered, press and hold down the
PROGRAM button for 8 seconds to enter ID Modification mode.
The STATUS LED will turn amber.
The RSSI/ID LED will flash red once to indicate that the ID is currently set to 1.
2.
Press the PROGRAM button to select the desired ID.
The ID can be selected from 1 through 6 by pressing the PROGRAM button. The ID will increase by one
each time the button is pressed.
3.
Press and hold down the PROGRAM button for 5 seconds to assign the ID to the repeater.
The RSSI/ID LED will turn red.
4.
Release the PROGRAM button to reset the repeater.
The STATUS LED will turn amber for 2 seconds and then the repeater will return to Operation mode, or
Easy Registration mode if the repeater is unregistered.
14
Installation Manual
Document Version 2010-06