PTP 250 User Guide
Saving the system configuration
Save the system configuration in the following situations:
•
After a new unit has been fully configured as described in this chapter.
•
After any change has been made to the configuration.
•
Before upgrading the unit to a new firmware version.
•
After upgrading the unit to a new firmware version.
The process for restoring a unit to a previously saved configuration is described in
Restoring the system configuration
Saving the system configuration
To save the current configuration, proceed as follows:
1
Select menu option System, Configuration, Save And Restore. The Save and
Restore page is displayed
2
Select Save Configuration File.
3
Save the configuration file to a PC hard drive.
The configuration file format is:
mm-mm-mm-mm-mm-mm_iii-iii-iii-iii.cfg
Where:
Figure 6-25 Save & Restore page
phn-2182_003v004 (Oct 2011)
on page 7-24.
(Figure
mm-mm-mm-mm-mm-mm
iii-iii-iii-iii
6-25).
Is:
MAC address of unit
IP address of unit.
UNDER DEVELOPMENT
Saving the system configuration
6-35