Samsung OfficeServ 7200 Programming Manual page 337

CHAPTER 2. MMC Programming
[830] ETHERNET PARAMETERS
This MMC provides a mean to configure the Internet Protocol (IP) addressing of the MCP
card.
No Parameter
00 SYSTEM IP ADDR
01 SYSTEM GATEWAY
02 SYSTEM NET MASK
03 SYSTEM RESET
04 SYSTEM IP TYPE
05 SYSTEM PUBLIC IP
07 SYSTEM DHCP
MODE
08 SYSTEM MAC ADDR
09 DATA SERVER IP
10 FEATURE SVR IP
12 PCMMC ADDRESS
13 SM MANAGER IP
14 CTI SERVER ADDR
17 NEWS ADDRESS
Samsung Business Communications
Specifies the IP address for the MCP card.
Specifies the designated gateway IP address used for contacting
IP devices beyond the local network subnet.
Specifies the IP subnet mask.
This parameter is used by the system to calculate the range of IP
devices (subnet) that are within 'direct reach' of the MCP (without
having to go through the designated network IP gateway).
Prompt to reset system MCP when system IP address is changed.
This reset is same as FAST RESTART in MMC 811.
Specifies if the system will be routing data over a public or private
network.
The MCP will originate communications to IP phones and VoIP
connections outside the local network using this IP address. Com-
munications to/from this IP will require involvement of the MGI
card. The system identifies communications to/from this address
as 'public'. This allows devices, on remote networks/subnets, to
establish communications with the system, without exposing the
LAN. See 'SYSTEM IP TYPE'.
Specifies if the MCP card is automatically assigned an IP address
from the Data Server (WIM board, the OS7200 router)
For reference, and cannot be changed. The unique hardware
(MAC) address of the MCP card.
IP address of Data Server
IP address of separate Feature Server
When the system wants to connect to PCMMC, it will be sent to
this IP address for a connection message. (Reserved for future
use.)
Not used.
IP address of CTI Server
IP address of News Server
OfficServ 7200 Programming Guide
Description
2-306