Hitachi C 15 FB Handling Instructions Manual page 23

12. Don't overreach. Keep proper footing and balance at all times.
13. Maintain tools with care. Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have reparired by authorized
service center. Inspect extension cords periodically and replace if damaged. Keep
handles dry, clean, and free from oil and grease.
14. Disconnect tools. When not in use, before servicing, and when changing
accessories, such as blades, bits, cutters.
15. Remove adjusting keys and wrenches. Form habit of checking to see that keys and
adjusting wrenches are removed from tool before turning it on.
16. Avoid unintentional starting. Don't carry plugged-in tool with fi nger on switch. Be
sure switch is off when plugging in.
17. Outdoor use extension cords. When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
18. Stay alert. Watch what you are doing. Use common sense. Do not operate tool
when you are tired.
19. Check damaged parts. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting, and any other conditions that may
aff ect its operation. A guard or other part that is damaged should be properly
repaired or replaced by an authorized service center unless otherwise indicated
else-where in these handling instructions. Have defective switches replaced by
authorized service center. Do not use tool if switch does not turn it on and off .
20. Use the power tools only for applications specifi ed in the Handling Instructions.
21. To avoid personal injury, use only the accessories or attachment recommended in
these handling instructions or in the HITACHI catalog.
22. Let only the authorized service center do the repairing.
The manufacturer will not be responsible for any damages or injuries caused by
repair by unauthorized persons or by mishandling of the tool.
23. To ensure the designed operational integrity of power tools, do not remove
installed covers or screws.
24. Do not touch movable parts or accessories unless the power source has been
disconnected.
25. Use your tool at lower input than specifi ed on the nameplate; otherwise, the fi nish
may be spoiled and working effi ciency reduced by motor overload.
26. Do not wipe plastic parts with solvent. Solvents such as gasoline, thinner, benzine,
carbon tetrachloride, alcohol, ammonia and oil containing chloric annex may
damage and crack plastic parts. Do not wipe them with such solvent. Wipe plastic
parts with a soft cloth lightly dampened with soapy water.
27. Use only genuine HITACHI replacement parts.
28. Disassemble this tool only for replacement of carbon brushes.
29. Use the exploded assembly drawing on these handling instructions only for
authorized servicing.
23
English