Make Connections - Bosch DIVAR 3000 Operation Manual

DIVAR 2000 / DIVAR 3000 / DIVAR
5000
5.2

Make connections

Notice!
Use only PoE approved devices.
1.
2.
3.
Optional connections (depending on model)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Connect a Bosch Intuikey keyboard cable to the
11. Connect an eSATA storage device to the
12. Connect the DIVAR to an approved ground point. Use the ground screw (supplied in the
Bosch Security Systems
Qty Component
1 Split cable for loop through to 25-pin D-connector (only for DIVAR 5000 hybrid
models)
1 RJ11 adapter cable to connect Bosch Intuikey keyboard
Installation guides for Recorder, HDD, plus safety instructions
Connect the cameras to the
– If using PoE connector, power is supplied to the camera via the Ethernet cable
compliant with the Power-over-Ethernet standard.
– Use an external switch to connect more cameras to a single RJ45
Connect monitor A to the
Connect the USB mouse to a USB port (back or front panel).
On DIVAR 5000 models, connect a second dual monitor to the HDMI MON.B (hybrid
models) or HDMI MON.A2 (network models) connector.
Connect up to 4 audio signals to the
Connect 1 microphone to the
Connect 1 RCA (CINCH) output from
Connect up to 16 alarm inputs to the
blocks) – see description in Hardware setup.
Connect up to 6 alarm outputs to the
blocks) – see description in Hardware setup.
Connect a pan/tilt/zoom control unit to the
description in Hardware setup.
Connect to your network via the RJ45 ETHERNET connector
Pair Category 5e cable).
Connect extra video out cables to the
devices (only for DIVAR 5000 hybrid).
adaptor (only for DIVAR 5000) – see description in Hardware setup.
accessory bag) to attach a ground cable to the DIVARback panel ground point
or connectors.
output, or the
RCA (CINCH) inputs.
RCA (CINCH) input.
to the monitor or an audio amplifier.
connector (via the supplied terminal
connector (only for DIVAR 5000).
Operation Manual
Installation | en
output.
connector (via the supplied terminal
(only for hybrid models) – see
(use Shielded Twisted
ports if loop through is required to other
connector using the supplied
2016.09 | v1.0 | AM18-Q0717
13
port.
.