HP D300 Operating Manual page 67

Table 6-1 Error message guide
Error message text
Unable to home the stage. (Could not move to
destination.)
Unable to home the stage. (Lost comms?)
Unable to home the stage. (Lost comms?)
Unable to initialize Dispenseheads. (Could not
move to destination.)
Unable to initialize Dispenseheads. (Lost
comms?)
Unable to initialize the following hardware
components: Firing System
Unable to initialize the following hardware
components: Pogo
Unable to initialize the following hardware
components: Stage
Unable to initialize the well plate. (Could not
move to destination.)
Unable to initialize the well plate. (Lost comms?)
Unable to initialize the well plate. (No plate
detected.)
Unable to initialize the well plate. (Plate is too
thick.)
Error message title
Startup Error
Stage Home Error
Startup Error
Cassette Initialization
Error
Cassette Initialization
Error
Startup Error
Startup Error
Startup Error
Plate Initialization Error
Plate Initialization Error
Plate Initialization Error
Plate Initialization Error
HP D300 Digital Dispenser
Recommended action
Ensure that nothing is obstructing the
motion of the destination plate holder,
and restart the software.
Ensure that nothing is obstructing the
motion of the destination plate holder
and that the Dispensehead Cassette is
seated properly. Restart the software if
retry fails.
Ensure that nothing is obstructing the
motion of the destination plate holder,
and restart the software.
Ensure that nothing is obstructing the
motion of the pogo mechanism and that
the Dispensehead Cassette is seated
properly. Restart the software if retry
fails.
Ensure that nothing is obstructing the
motion of the pogo mechanism, and
restart the software.
Close the software, check the USB
connection between the dispenser and
your computer, turn the dispenser on,
and restart the software.
Close the software, check the USB
connection between the dispenser and
your computer, turn the dispenser on,
and restart the software.
Close the software, check the USB
connection between the dispenser and
your computer, turn the dispenser on,
and restart the software.
Ensure that nothing is obstructing the
motion of the destination plate holder.
Restart the software if retry fails.
Ensure that nothing is obstructing the
motion of the destination plate holder
and restart the software.
Ensure that a plate is on the destination
plate holder and use a plate with a
thickness greater than 12mm.
Ensure that a plate is on the destination
plate holder and use a plate with
thickness less than 18mm.
67