Table of Contents
Advertisement
Hardware error
Backlight error.
Fan error.
Panel error.
I/F error.
System error.
Invalid operation due to high temperature.
Input signal
No Signal
Unsupported
"Input Configuration" is different from Payload.
Operation
Invalid operation.
"Protect Settings" is on.
"CDL/User LUT Bypass" is on.
Invalid Password.
USB memory
USB memory is not connected.
Unsupported USB memory.
96
Error Messages
Message
Description and Action
Disconnect the power cord, reconnect it, and then
turn on the power.
If the message persists, contact Canon Customer
Center.
The temperature inside the main unit is high. Turn off
the power and wait until the fan stops.
Displayed when there is no video signal input.
Unsupported video signal is input. Check the
supported signal format (
Check the "Input Configuration" (
Information" (
74) settings. Reset any incorrect
"Input Configuration" settings.
Operation is disabled. Check the setting items.
To use the OSD menu, move the selection frame
to "Protect" and press the jog dial for approximately
3 seconds.
When "CDL/User LUT Bypass" is turned "On", you
cannot adjust "Power", "Saturation", "Offset", or
"Slope".
Enter the correct password.
Correctly connect the USB memory to the USB port
of this main unit.
Check the USB memory format and make sure it is
not protected.
78).
49) and "Signal
Advertisement
Table of Contents
