Craftsman 917.20402 Operator's Manual page 25

5, INSTALL ANTI-SWAY BAR (S)
(IF EQUIPPED)
ANTI-SWAY BAR (S)
.,_ Towards Towards
Transaxle MowerDeck _'_
90" End integrated Washer End
• From right side of mower, first insert
90° end of anti-sway bar (S) into hole in
transaxIe bracket (_, located near left
rear tire in front of transaxfe.
NOTE: Flashlight may be helpful.
TransaxleBracket (T)
LocatedBetween RearTires
NOTE: Depending on model, bracket(T) may
be different than shown but hole for anti-sway
bar will be in same position/location,
• Pivot the integrated washer end of anti-
sway bar (S) towards mower deck bracket
on right side of mower. Insert integrated
washer end of bar into hole in rear mower
bracket (D), Move mower as needed to
insert integrated washer end of bar into
rear mower bracket (D).
• Secure with small washer and small
retainer spring as shown.
D. RightSide Rear MowerBracket
S. Anti-SwayBar
"11.TransaxJe Bracket
l 1
6. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS
, Position front hole inside suspension arm
(A) over pin on outside of tractor chassis
and secure with large washer and large
retainer spring (B),
Repeat on opposite side of tractor.
A, MowerSide SuspensionArms
B. RetainerSpring
D. RightSide RearMower Bracket
7. ATTACH REAR LIFT LINKS (C)
• Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower.
• Lift rear corner of mower and position slot
in link assembly over pin on rear mower
bracket (D) and securewith largewasher
and large retainer spring.
- Repeat on opposite side of tractor.
25