HP FlexNetwork MSR2003 Configuration Manual page 284

Figure 108 Network diagram
Configuration procedure
You must configure the DHCPv6 server before configuring the DHCPv6 client. For information about
configuring the DHCPv6 server, see
# Configure an IPv6 address for GigabitEthernet 2/0/1 that connects to the DHCPv6 server.
<Router> system-view
[Router] interface gigabitethernet 2/0/1
[Router-GigabitEthernet2/0/1] ipv6 address 1::2/48
# Configure GigabitEthernet 2/0/1 to use DHCPv6 for IPv6 address and prefix acquisition. Specify
IDs for the dynamic IPv6 prefix and dynamic DHCPv6 option group, and configure the client to
support rapid address and prefix assignment.
[Router-GigabitEthernet2/0/1] ipv6 dhcp client stateful prefix 1 rapid-commit
option-group 1
[Router-GigabitEthernet2/0/1] quit
Verifying the configuration
# Display DHCPv6 client information. The output shows that the DHCPv6 client has obtained an IPv6
address, an IPv6 prefix, and other configuration parameters from the DHCPv6 server.
[Router] display ipv6 dhcp client
GigabitEthernet2/0/1:
Type: Stateful client requesting address and prefix
State: OPEN
Client DUID: 00030001d07e28db74fb
Preferred server:
Reachable via address: FE80::2E0:1FF:FE00:19
Server DUID: 0003000100e001000000
IA_NA: IAID 0x00000a02, T1 50 sec, T2 80 sec
Address: 1:1::2/128
Preferred lifetime 100 sec, valid lifetime 200 sec
Will expire on Mar 27 2014 at 15:29:34 (198 seconds left)
IA_PD: IAID 0x00000a02, T1 50 sec, T2 80 sec
Prefix: 12:34::/48
Preferred lifetime 100 sec, valid lifetime 200 sec
Will expire on Mar 27 2014 at 15:29:34 (198 seconds left)
DNS server addresses:
2000::FF
Domain name:
"Configuring the DHCPv6
270
server."