ABB ScreenMaster RVG200 Operating Instructions Manual page 149

ScreenMaster RVG200
Paperless recorder
Source Name
Digital Input States
Digital I/P A1 to D6
Comms Dig I/P 1 to 24
Alarm state 1A to 24D
Alarm ack state 1.1A to 6.6D
Alarm group 1 to 12
Any Alarm
New Alarm
Real-time alarm 1 to 4
Run state 1A to 24B
Wrap pulse 1A to 24B
1st Stage O/P 1A to 24B
Table A.1 Signal sources (Continued)
OI/RVG200-EN
Digital input states.
Digital signals received from analog input modules fitted at module positions A to D (if
input Type is set to Volt-free Digital Input or 24V Digital Input during configuration –
see page 90) and digital inputs from hybrid modules fitted at module positions C and
D.
Available only if the module is fitted.
Digital input states.
Digital signals received via MODBUS serial link – see Table B.16, page 164.
Alarm states.
Available only if the relevant alarm is enabled during configuration.
Alarm acknowledge states.
Acknowledged alarm = 0; Unacknowledged alarm = 1. Process, Latch and
Annunciator alarms only.
Available only if the relevant alarm is enabled during configuration.
Alarm groups.
Active only if any of the alarms assigned to a group are active.
Available only if any alarms are enabled during configuration.
Active only if any of the enabled alarms are active.
Available only if there is at least one alarm enabled during configuration.
Causes an e-mail to be generated if any alarm becomes active.
Available only as a source for e-mail triggers.
Real-time alarm states.
Available only if the relevant alarm is enabled during configuration.
Totalizer run states.
Active while the totalizer is running.
Available only if the totalizer option is enabled and the relevant totalizer is enabled
during configuration.
Totalizer wrap pulse.
If is set to On (see page 102) – active for 1 second when the
Wrap enable
predetermined count has been reached.
If is set to Off (see page 102) – active when the predetermined count has
Wrap enable
been reached and remains active until the totalizer is reset
Available only if the totalizer option is enabled and the relevant totalizer is enabled
during configuration.
Totalizer first stage output (intermediate count).
Active for 1 second when the intermediate count has been reached.
Available only if the totalizer option is enabled and the relevant totalizer is enabled
during configuration.
Appendix A – Signal sources
Description
147