HP MSR4080 Configuration Manual page 91

# Enable QPPB on interface GigabitEthernet 2/1/0.
[RouterB] interface gigabitethernet 2/1/0
[RouterB-GigabitEthernet2/1/0] bgp-policy destination ip-prec-map
# Configure a QoS policy.
[RouterB] traffic classifier qppb
[RouterB-classifier-qppb] if-match ip-precedence 4
[RouterB-classifier-qppb
[RouterB] traffic behavior qppb
[RouterB-behavior-qppb] car cir 512 red discard
[RouterB-behavior-qppb] quit
[RouterB] qos policy qppb
[RouterB-qospolicy-qppb] classifier qppb behavior qppb
[RouterB-qospolicy-qppb] quit
# Apply the QoS policy to the incoming traffic of GigabitEthernet 2/1/0.
[RouterB] interface gigabitethernet 2/1/0
[RouterB-GigabitEthernet2/1/0] qos apply policy qppb inbound
[RouterB-GigabitEthernet2/1/0] quit
Verifying the configuration
# Verify that the related routes on Router A take effect.
[RouterA] display ipv6 routing-table
Destinations : 7
Destination: ::1/128
NextHop
Interface
Destination: 1::/64
NextHop
Interface
Destination: 1::1/128
NextHop
Interface
Destination: 168::/64
NextHop
Interface
Destination: 168::1/128
NextHop
Interface
Des tination: FE80::/10
NextHop
In terface
] quit
Routes : 7
: ::1
: InLoop0
: ::
: GE2/1/0
: ::1
: InLoop0
: ::
: GE2/1/1
: ::1
: InLoop0
: ::
: NULL0
89
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
rence: 0
Prefe
Cost : 0