Siemens sinumerik 840d Programming Manual page 506

Tables
15
15.1 List of instructions
TAN Tangent (trigon. function)
TANG Determine tangent for the follow-up from both specified
leading axes
TANGOF Tangent follow-up mode OFF
TANGON Tangent follow-up mode ON
TCARR Request toolholder (number "m")
1
TCOABS Determine tool length components from current tool
orientation
TCOFR Determine tool length components from orientation of
active frame
5
TILT Side angle
TMOF Deselect tool monitoring function
TMON Select tool monitoring function
TO Defines the end value in a FOR counter loop
TOFRAME Set current programmable frame to tool coordinate
system
TOLOWER Convert letters of the string into lowercase
TOUPPER Convert letters of the string into uppercase
TR Parameter for access to frame data: Translation
TRAANG Transformation inclined axis
TRACEOF Circularity test: Transfer of values OFF
TRACEON Circularity test: Transfer of values ON
TRACON Transformation concatenated
TRACYL Cylinder: Peripheral surface transformation
TRAFOOF Switch off transformation
TRAILOF Synchronous coupled motion of axes OFF
(trailing OFF)
TRAILON Synchronous coupled motion of axes ON
(trailing ON)
15-506
Real
Integer m=0: Deselect
active toolholder
Required after
resetting machine,
e.g.
by manual setting
Real
T number required
only if tool with this
number is not
active.
T No. = 0:
Deactivate
monitoring function
for all tools
Several
transformations
settable per
channel
see TRAANG
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
12.98
TCARR=1
TMOF (T No.)
TMON (T No.)
TRAFOOF( )
 Siemens AG 2000. All rights reserved
15
m 42
m 42
m
s 3