Figure 49
1. Transmission case drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it
(Figure
49).
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level (approximately
17 liters [18 quarts]); refer to Checking the Hydraulic
Fluid.
8. Start the engine and check for oil leaks. Allow the
engine to run for about five minutes, then shut it off.
9. After two minutes, check the level of the hydraulic
fluid; refer to Checking the Hydraulic Fluid.
3. Hydraulic reservoir drain
plug
Cleaning
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
45