Ethernet Wan Connections - D-Link DSL-2750U User Manual

DSL-2750U Wireless N ADSL2+ USB Modem Router
User Manual
11. Go to the Advanced / Interface grouping page.
12. Create a group containing the WAN connection of the Bridge type and the LAN 2 port.
13. Create another group containing the WAN connection of the Dynamic IP type, the LAN 3
port, and the wireless interface.
14. Save the router's settings.

Ethernet WAN Connections

In some cases, it is necessary to assign two WAN connections to one physical interface.
For example, your private Ethernet line is connected to the LAN 3 port of the router. The ISP
provides the IPTV service. You need to configure a WAN connection of the Bridge type for the set-
top-box connected to the LAN 2 port of the router and a WAN connection of Dynamic IP type for
the computer connected to the LAN 4 port of the router and the laptop connected to the wireless
interface of the router.
To configure the router, follow the steps below:
1. Go to the Advanced / Interface grouping page.
2. Place the mouse pointer on the LAN3 port and click the Make WAN line in the menu
displayed.
3. On the opened page, select the VLAN MUX Mode value from the Ethernet WAN type
drop-down list.
4. Click the Save link.
5. Go to the Net / WAN page and click the Add button.
6. Select the Bridge value from the Connection Type drop-down list.
7. Select the LAN3 value from the Interface drop-down list.
8. In the VLAN section, select the Allow to create several connections assigned to
this port checkbox.
9. Click the Save button.
10. Click the Add button again.
11. Select the Dynamic IP value from the Connection Type drop-down list.
12. Select the LAN3 value from the Interface drop-down list.
Figure 125. Groups of ports for the created WAN connections.
Page 171 of 174
Operation Guidelines