Table of Contents
Advertisement
Navi Bars
Settings folder
To open this menu, you will be asked to enter your access code.
The access code is set to 1234 at the factory.
The procedure is performed the same way it was during the First-
Time Installation. For more information, see page 10.
Settings folder
To open this menu, you will be asked to enter your access code.
The access code is set to 1234 at the factory.
The procedure is performed the same way it was during the First-
Time Installation. For more information, see page 10.
Settings folder
To open this menu, you will be asked to enter your access code. The
access code is set to 1234 at the factory.
You can adjust the audio/video settings for your receiver.
• Press opt to view the TV picture on the screen.
TV screen format
Select your TV screen format.
The 4:3 format is the standard format for most TV screens.
Select 16:9 for a wide-screen TV.
Adjust picture horizontally
Adjust the horizontal position of the TV picture using the cursor
left/right button.
Set transparency level
Adjust the transparency level of the graphics in the menus using the
cursor left/right button.
Select digital audio format
Select an audio format for digital output (the upper audio output
on the rear of the Mediamaster). Select AC-3 when the sound is
transmitted in Dolby™ Digital format. Select PCM for ordinary digital
sound. NOTE: when you select AC-3, there will not be any sound
output from the analogue audio connections.
GB 28
Antenna
—
Channel
—
TV
—
Advertisement
Table of Contents
