Panasonic AW-RP50E Operating Instructions Manual page 32

Setting the functions when the unit is linked with the switcher
Bus setting
From the [SETUP] menu, select [SW LINK] and display
[BUS]. Then set the material (AUX, PVW, PinP or KEY) to be
sent to the switcher.
3 . B U S
The materials set using this item are sent from the remote
camera to the switcher when the remote camera has
been selected using one of the unit's CAMERA STATUS/
SELECTION buttons.
Control can also be exercised by assigning this setting to a
USER button (BUSCONT).
Focus assist setting
From the [SETUP] menu, select [SW LINK] and display
[FASIST]. Then set On or Off.
4 . F A SI S T
When "On" is selected as this item's setting, the images of
the AUX bus output from the switcher will be switched to the
images of the remote camera selected by the unit.
Conversely, when "Off" is selected, the switcher will switch
the images of the AUX bus output from the switcher to the
images of its multi view display.
Camera information setting
From the [SETUP] menu, select [SW LINK] and display
[CAMSEL]. Then set On or Off.
5 . C A MS E L
When "On" is selected as the item setting, an icon appears
at the bottom left of the image of the remote camera
selected by the unit on the switcher's multi view display.
When a remote camera has been selected, its information is
sent from the unit to the switcher.
A U X
O f f
O f f
31 (E)
OA tally setting
From the [SETUP] menu, select [SW LINK] and display
[TALLY_IP]. Then set On or Off.
6. T A L L Y _I P
When "On" is selected as the item setting, the unit receives
the tally information (tally ON/OFF) sent periodically from
the switcher through the network, and it sends the ON or
OFF instruction to the remote cameras in which changes
have occurred.
[ Concerning the tally information transferred through
the network]
After receiving the tally information (Input1 to Input5) from
the switcher through the network, the unit sends the ON or
OFF instruction to the remote cameras.
Based on the relationship between the image output (remote
camera) and image input (switcher) which have been set
using the unit's menu, the remote camera to which the
tally instruction is sent in response to the tally information
received from the switcher is identified, the tally indicator of
that remote camera is lit in red, and the tally ON instruction
is sent to the remote camera.
The Tally ON instruction is also sent to the remote cameras
which are not in the selected camera group.
AW-HS50
Input1
IP RP50CAMNo
Input1 CAM1
Input2 CAM2
Input3 CAM3
Input4 CAM4
Input5 CAM5
In response to inputs 1 to 5 from GPI Input, tally indicators
CAM1 to CAM5 are lit in red, and the tally ON instruction is
sent to the remote cameras concerned.
Only CAM1 to CAM5 serve as the GPI Input tally.
This means that when a camera group other than No.1 is
selected, the tally indicators will go off.
O f f
AW-RP50
TALLY
1 2 3 4 5
CAM
Input3
GPI Input
1 2 3 4 5
Group 1
Group 2