Panasonic MX-151SG2 Operating Instructions Manual page 13

3
5
4
3
2
1
當碾磨完成後，將選擇器旋鈕設至「0」的位置。
斷開電源插頭與電源插座的連接。
從本體上取下碾磨機容器與碾磨刀座組立。將其倒置後，輕輕拍打，附在碾磨刀上的材料便會脫落。
將碾磨刀座逆時針轉動，便可從容器上取下。將材料全部倒出。
直至碾磨機運轉完全停止為止，再將手移開容器。
拔出電源插頭時，不要拉扯電線，請握住插頭端部，再將其拔出。
0_MX-151SG1-050.indd 13
After the ingredients have been mixed, set the selector knob to the "0" position.
Disconnect the power plug from the power outlet.
Remove the mill container base from the motor housing, turn it upside down, and tap the
container gently with your hand to dislodge the ingredients from the cutter.
Remove the mill container base as shown in the figure, and take out the processed
ingredients.
Wait for the container to stop rotating before removing your hand.
When disconnecting the power plug, be absolutely sure to take hold of the
molded plug.
Never pull on the cord.
13
2010/05/24 11:31:15