Updating Tape Cartridge Inventory (Operations > Perform Inventory); Rebooting The Library (Operations> Reboot Library); Enabling Password Locks (Operations > Enable Library Password Locks) - HP StoreEver MSL2024 User And Service Manual

7. Use Previous or Next to select from the possible destinations as follows:
Mailslot
Right Magazine
Left Magazine
Drive 1
Drive 2 (if two drives are present)
8. When the correct destination is displayed, press Enter to select.
9. If the destination selected is a magazine, use Previous or Next to display the slot. Only
empty slots are listed.
Once the correct slot is displayed, press Enter to select. The device now moves the tape from
the selected source, to the selected destination. While the device moves the tape, the screen
displays Moving Tape. Once the tape has been moved, the screen displays either Move
Complete, or Move Failed. If the move failed, press Enter to display the error code and message
explaining the failure.
Updating tape cartridge inventory (Operations > Perform Inventory)
This option updates the device's tape cartridge inventory. The device checks each slot and drive
to determine which tape, if any, is present.
To update the tape cartridge inventory:
1. From the Home screen, press Previous or Next until the screen displays Operations. Press
Enter to select.
2. Press Previous or Next until the screen displays Perform Inventory. Press Enter to select.
3. While the inventory is in progress, the screen displays Inventory in Progress...
4. The library now checks the drive and each slot for the presence of a tape to update the
inventory information. The Ready LED blinks during this operation.
NOTE: This command is only needed if the inventory in the device is different than the inventory
displayed on the front panel, which would not happen under normal conditions.
Rebooting the library (Operations> Reboot library)
This option reboots the device and forces a new cartridge inventory, clearing any current error
condition.
CAUTION:
operation to fail. Use this option if the device is in an error state.
To reboot:
1. From the Home screen, press Previous or Next until the screen displays Operations. Press
Enter to select.
2. Press Previous or Next until the screen displays Reboot Library. Press Enter to select.
3. The Ready LED blinks during the reboot operation.
Enabling password locks (Operations > Enable Library Password Locks)
This option locks the restricted areas. This is typically used if you do not want to wait for the time
out to reset the locks. Power cycling or rebooting the device also resets the locks.
To enable the password locks:
1. From the Home screen, press Previous or Next until the screen displays Operations. Press
Enter to select.
2. Press Previous or Next until the screen displays Enable Library Password Locks. Press
Enter to select.
106 Operating the tape library
This option interrupts the current backup or restore operation and causes the